2003 ICC ANSI A117.1 PDF

Trademarks: “ICC,” the International Code Council logo and “Accessible and Usable Buildings and Facilities (ICC/ANSI Al )” are trademarks of the. The edition of ANSI Standard A presented the first criteria for requirements and identify changes from the edition. . ICC/ANSI A ICCANSIAAccessible and Useable Buildings and Facilities-The specifications in this standard make sites, facilities, buildings and elements accessible.

Author: Daidal Goltigal
Country: Laos
Language: English (Spanish)
Genre: Spiritual
Published (Last): 20 February 2013
Pages: 195
PDF File Size: 11.26 Mb
ePub File Size: 19.28 Mb
ISBN: 762-1-46611-774-4
Downloads: 8501
Price: Free* [*Free Regsitration Required]
Uploader: Shakajin

The rise for any ramp run shall be 30 inches mm maximum.

Where handrails are provided along walking surfaces with slopes not steeper than 1: Elevator door clear opening width shall comply with Table By combining the accessibility provisions of the IBC with the technical requirements of the A The signal-to-noise ratio for internally generated noise in assistive lis- tening systems shall be 18 dB minimum. Handrails shall be at a consistent anxi above stair nosings, ramp surfaces and walking surfaces.

Illustrative figures are numbered the same as corre- sponding text to simplify the use of the Standard. Turning spaces shall comply with Sec- tion Special Rooms and Spaces 75 Figure Accessible Routes inches mm above the floor. If provided, occu- pancy-sensing automatic controls shall activate the stairway lighting so the luminance level required by Section Regulatory R – Members in this category include federal agencies, representatives of regulatory agencies or organizations that promulgate or enforce snsi or standards; and their respective associations.

Plumbing Elements and Facilities General When pressure is removed from the up or down scan button for more than 2 seconds, the last floor selected shall be registered as a car call. The Inter- national Symbol for Accessibility, complying with Section Amazon Rapids Fun stories for kids on the go.

The floor surface of wheel- chair space locations shall have a slope not steeper than 1: The uppercase letter “I” shall be used to determine the allowable height of all characters of a font. Where receipts are provided, speech output devices shall provide audible bal- ance inquiry information, error messages, and all other information on the printed receipt neces- sary to complete or verify the transaction.


Accessible urinals shall comply with Section Access aisles serving vehicle pull-up spaces shall be 60 inches mm minimum in width. Guardrails or other barriers shall be provided where object protru- sion is beyond the limits allowed by Sections Sites, facilities, buildings, and elements required to be accessible shall comply with the applicable provisions of Chapters 3 through 9.

State Building Code – ICC/ANSI A Code Interpretations

Open risers shall not be per- mitted. The detectable warning shall be located so the edge nearest the curb line is 6 inches mm to 8 inches mm from the curb line. Tactile symbols required by Section Alexa Actionable Analytics for the Web.

The intent of these sections is to allow a person with a physical disability to independently get to, enter, and use a site, facility, building, or ele- ment.

Vertical grab bars required by Sections Grab bars in accessible toilet or bathing facilities shall comply with Section Clear floor space is not required at drive up only automatic teller machines and fare machines.

Page 1 of 1 Start over Page 1 of 1. Door spring hinges shall be adjusted so that from the open posi- tion of 70 degrees, the door shall move to the closed position in 1. Angela Van Etten, J. Exposed edges of carpet shall be fastened to the floor and shall have trim along the entire length of the exposed edge.

Inside handrails on switchback or dogleg stairs or ramps shall be continuous between flights or runs. In detention or correction facilities, grab bars are not required to be installed in housing or holding cells or rooms that are specially designed without protrusions for purposes of suicide prevention.

Viewing distance shall be measured as the horizontal distance between the character and an obstruction pre- venting further approach towards the sign.


Doors to a toilet and bathing room for a single occupant, accessed only through a private office and not for common use or public use shall be permitted to swing into the clear floor space, provided the swing of the door can be reversed to meet Section Type B units shall comply with Section 1 A vertical grab bar 18 inches mm minimum in length shall be provided on the control end wall 3 inches 76 mm minimum to 6 inches mm maximum above the horizontal grab bar, and 4 inches 1 02 mm maximum inward from the front edge of the bathtub.

At the top of a stair flight, handrails shall extend horizontally above the.

ANSI A117.1 (2003): Accessible and Usable Buildings and Facilities

End door clear opening width shall be 32 inches mm minimum. Unless specified otherwise, figures are not part of the Standard.

A tactile star shall be provided on both jambs at the main entry level. Each grab x117.1 shall be located 1 5 inches mm maximum from the head end wall and extend to 12 inches mm maximum from the control end wall.

Where handrails are provided on the ramp run, the clear width shall be measured between the handrails. Where separate tactile and visual characters with the same information are provided, the height of the tactile upper- case letter “I” shall be permitted to be V 2 inch 13 mm minimum.

A clear floor space complying with Section shall be provided. Fixed side- wall grab bars shall be 42 inches 1 mm min- imum in length, located 12 2003 mm maximum from the rear wall and extending 54 inches 1 mm minimum from the rear wall. The tactile indica- tion shall be three raised dots, spaced V 4 inch 6.