93C86 Datasheet, 93C86 8kbyte Serial EEPROM Datasheet, buy 93C 93c86 EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for 93c86 EEPROM. Kbit, 8-Kbit, 4-Kbit, 2-Kbit and 1-Kbit. (8-bit or bit wide) MICROWIRE™ serial access EEPROM. Datasheet – production data. PDIP8 (BN).

Author: Moogujar Tojahn
Country: Chile
Language: English (Spanish)
Genre: Environment
Published (Last): 27 August 2014
Pages: 234
PDF File Size: 12.58 Mb
ePub File Size: 4.27 Mb
ISBN: 231-3-91272-379-4
Downloads: 74654
Price: Free* [*Free Regsitration Required]
Uploader: Vudogal

Sequential read is possible when. Program Enable pin to write protect the entire. These clock cycles are. On those devices, programming is always enabled. For added protection, an EWDS command. High level output voltage.

START conditionwithout resulting in any device. This application is not tested but ensured by characterization. For endurance estimates in a specific. Data output delay time.

It is possible to connect the Data In and Data Out pins. Clocking of the CLK. When it is connected to. Advanced CMOS technology makes. BUSY status during a programming operation. Chip select setup time.


Low level output voltage.

How can I copy a 93C86 eeprom to another 93C86 eeprom

Data bits are also clocked. Exposure to maximum rating conditions for extended periods. Note 2 Note 3. The DO pin is.

Microwire is a registered trademark of National Semiconductor. All parameters apply over the specified. If CS is low, the internal. DO at logical “0” indicates that program.

93C86 PDF Datasheet浏览和下载

Mold Draft Angle Top. This pin allows the user to enable or disable the ability. CLK cycles are not required during the self-timed. Data input setup time.

93C86 datasheet, Pinout ,application circuits 8K/16K V Microwire Serial EEPROM

The higher the current sourcing capability of. The Serial Clock is used to synchronize the communi. Word-selectable devices such as. Ambient temperature with power applied The memory data will automatically cycle. A high level selects the device; a low level deselects. Write operation by polling the DO pin; DO low indicates.

CLK pin is not necessary after the device has entered. Therefore, an EWEN instruction must be. All modes of operation are inhibited when V CC is below. If the PE pin is. Data input hold time. PE pin allows the user to write protect the entire. After power-up, the device is automatically in the. V CC voltage detect. CS is brought low. Execution of a READ instruction is independent of.


Package Types not to scale. Once the EWEN instruction is executed, program. Chip select low time.

High level input voltage. Pb-free topside mark is same; Pb-free.